-2-
OPERATING PROCEDURE
2.1 Power On
Switch on the electrical supply (ie crane key switch) to the R180 system. During
the time the indicator is waiting for a valid radio transmission from the wind
speed sensor, the display will show three horizontal lines and the green status
light will lash.
Fig 4: R180 Waiting for transmission from the wind speed sensor
FLASHING
LIGHT
Once a reliable radio communication link is established with the wind speed
sensor, the wind speed value will be displayed and the green status light will
remain on without lashing.
If the status light lashes continuously for more than 30 seconds, it means the
display has not received a valid message from the wind speed sensor. Check
if the paper tag insulating the battery contacts has been properly removed. It
can also be incorrectly programmed to receive the wrong wind speed sensor.
To correctly program the R180 follow the programming ID number procedure
described at page 25.
55M0180GSE00-E
14
Installation and Operation Manual
R180 Wireless Wind Speed Indicator
