Wuxi Raycus Fiber Laser Technologies Co., Ltd.
User Guide of Raycus 1000W
～
2000W laser
15
nuts we provide. Failure to do so may lead to permanent equipment
damage.
When the customer is empting the cooling water of the laser
water-cooling system, please use compressed gas with pressure less than
0.5mpa, otherwise it will cause irreparable damage to the chiller.
Please set the water temperature in strictly accordance with
the requirements above. Too low temperature may lead to
condensation on the laser module and the output cable. This
can cause serious damage to the equipment.
Make sure that the water temperature reaches the set point
and the cooling system is working well before you start the
laser.(summer: 25
±
0.5
℃）；
winter
：
25
±
0.5
℃）
3.4 Installation Procedure
（1）
Place the product in an appropriate position, immobilize it if necessary.
（
2
）
Check if the power supply has the correct voltage (See Table 5 for the laser
model and corresponding input voltage ), and the earth line is connected, make
sure it is firm and reliable;
（
3
）
Connect the power cable and control cable to the product when power
supply is OFF;
（
4
）
Connect the power cable and control cable to the product when power
supply is OFF;
（
5
）
Check the output head and clean it if necessary. This procedure must be
performed by Raycus personnel or person authorized by Raycus. Make sure
the environment is clean, or the output cable may be contaminated.
（
6
）
Prevent the delivery cable from treading, pinching or excessive bending
during installation.
