Wuxi Raycus Fiber Laser Technologies Co., Ltd.
User Guide of Raycus 1000W
~
2000W laser
16
(7)
In the installation of laser output cable and output head process, please make
sure that the surrounding environment is clean, otherwise it may pollute the
output head (do not use fans, which actually may bring more dust).
(8)
The minimum bending radius of the output fiber cable of the 1000w laser
should not be less than 200mm under the non-working conditions, such as
transportation and storage, the minimum bending radius should not be less
than 300mm when the 1000w laser is working. The minimum bending
radius of the output fiber cable of the 1500w laser should not be less than
240mm under the non-working conditions, such as transportation and
storage. The minimum bending radius should not be less than 30cm when
the 1500w laser is working. When the 2000w laser is under the non-working
conditions, transportation, storage and so on, The minimum bending radius
of 400μm fiber core radium should not be less than 240mm, The minimum
bending radius of 600μm fiber core radium should not be less than 360mm.
When the 2000w laser is working, The minimum bending radius of 400μm
fiber core radium should not be less than 300mm, The minimum bending
radius of 600μm fiber core radium should not be less than 400mm.
All the cables can only be connected when power supply is
OFF. Hot plug may damage the laser.
The laser output optical cable should be kept as natural as
possible and not be distorted.
The too small bending radius of the output fiber cable will
damage the laser.