5
Trouble Shooting
Step 1: Basics
Check blue LED ‘power on’ light is illuminated on the back of the IP unit.
If
Yes
,
• Ensure power adjust is turned to the maximum level.
• Ensure Photocell is covered and if necessary adjust the photocell
sensitivity.
If
No
,
• Confirm that the PoE injector unit is fully functioning.
nB: Refer to manufacturer’s guide
• Check that the cable is fully intact, and not broken or split.
Step 2: Set-up Camera, lens and illumination
Check alignment of lamp
Check camera lens – fully open at night & set correctly.
Check model number to RayLED performance specification to
ensure required distance is achievable.
Step 3: Contact RayLED for further assistance
note down:
• Model, Angle and Wavelength ve any options
• Serial number of illuminator
• Camera make and model
• Lens make and model
