0049-2702-XXX Alliance Series Modems – USER MANUAL
08/05/2010
Rev. A
Page 22 of 197
To select a setting from a DEC/INC screen, use pushbutton 1 or 3 to cycle through the option
settings, when you see the standard you want, use pushbutton 2 to select the desired setting.
When you select a setting from an option screen, your selection flashes on and off on the LCD.
However, the selection does not take effect until you leave the SETUP menu.
Note the following important points –
•
Selected options do not become active until you leave the SETUP menu.
•
Changing most options will cause the modem to automatically reset.
•
The option choices you select are automatically saved by the ALX when you leave the
SETUP menu.
•
If you access any screens from the SETUP menu and then use AT commands or V.25bis
commands before exiting from the SETUP menu, you may change the modem’s
configuration with undesirable results. To prevent this, press the ENT pushbutton to exit
the SETUP menu prior to issuing any AT or V.25bis commands.
Example of How to Select an Option
The example that follows illustrates how options are selected. As you follow the steps below,
refer to the LCD flow chart in the back of this manual. When you are done, you can easily
restore default settings for the type of application you will be using by selecting the appropriate
Quick Setup (Table 1-1).
The example shows how to change the volume of the modem’s speaker from LOW or HIGH (the
default setting) to MEDIUM. To make this adjustment, you must locate the SPEAKER
VOLUME screen on the LCD. To reach this screen, you must first access MAIN MENU screen
2, then SETUP screen 4 and then MODEM SETUPS screen 5, as explained below:
After powering on the modem, press ENT to get the first screen of the MAIN MENU.
Press the right arrow pushbutton to go to screen 2 of the MAIN MENU (so the SETUP
menu can be selected):
Press pushbutton 1 to access the first screen of the SETUP menu:
