0049-2702-XXX Alliance Series Modems – USER MANUAL
08/05/2010
Rev. A
Page 24 of 197
How to Return to Default Settings
Quick Setup
The default settings are different for each of the Quick Setup configurations (2-wire dial Hayes,
2-wire dial V.25bis, etc.). To return to the Quick Setup default settings for any of these
configurations, go to the QUICK SETUP menu and select the desired configuration. Selecting a
Quick Setup will not delete stored phone numbers.
Factory Reset
A
factory reset
entirely reconfigures the modem to the state it was in when shipped from the
factory.
All modem options are changed to the factory default settings, and any phone
numbers stored in the modem’s memory are deleted.
To effect a factory reset, push and hold
in the right arrow pushbutton as you power up the modem until the words “FACTORY
DEFAULT” appear on the LCD.
OPTIONS
The rest of this chapter describes the options available from the ALX front panel. The options
are presented in the order in which they appear in the LCD chart (in the back of this manual).
For each option, all possible choices (available selections) are explained.
The line of text immediately below each option heading
indicates the applicability of the
option: A mode (i.e., Quick Setup mode) is listed only if the option is effective in that mode and
if it can be of practical use in that mode.
For a concise summary of the ALX options and option choices, see the LCD flow chart.
The
default settings for each option are listed in Appendices B and C.
- Quick Setups
All
modes
The Quick Setups (one for each operating mode) are unique in that they affect the entire
modem configuration. For complete details, see Chapter 1 and Appendix B.
-
Communication Standard (STD on the LCD)
All modes
This option (available on all models except the ALX V.32 and ALX V.32M) allows you to
select a communication standard: ITU-T V.34, V.32, V.33, V.29 or Bell 208. The standard
you choose specifies the primary operating mode (or modulation) the modem will use. (If you
