14.2 AIS prerequisites
You must have suitable AIS hardware connected to your
multifunction display to make use of the AIS functionality.
In order to run AIS, you will need:
• A receive-only AIS unit or a full AIS transceiver (a unit that sends
and receives).
• A VHF antenna.
• A GPS - to provide position data.
• The AIS layer enabled in the chart or radar application, as
appropriate.
Note:
A receiver will allow you to receive data about other
vessels in your area but will not allow other vessels to ‘see’ you.
A full transceiver transmits and receives AIS data, and therefore
allows you to receive data about other vessels. It also enables
other AIS-equipped vessels to see and receive information about
your vessel. This could include position, course, speed and rate
of turn data.
When the AIS unit is connected to your multifunction display, the
status of the unit is indicated by an AIS icon in the status bar.
You can connect an AIS unit to your multifunction display using
NMEA0183 or SeaTalk
ng
, depending on the AIS unit. If connecting
using NMEA0183, you will now need to specify the 38,400 baud
setting (
homescreen > Set-up > System Settings > NMEA
Set-up
) for the NMEA input port that communicates with the AIS
transceiver or receiver.
14.3 AIS context menu
The AIS function includes a context menu which provides AIS target
information and menu items.
The context menu provides the following AIS target data:
• MMSI
• CPA
• TCPA
• COG
• SOG
The context menu also provide the following menu items:
•
AIS Vector
— Switch target vectors On and Off.
•
AIS Data
— Switch on screen target data On and Off.
•
View Full Data
•
Add Buddy
— Add target to the buddy directory.
•
Acquire Target
(only available if Radar overlay is switched on.)
•
Slew thermal camera
(only available when thermal camera is
connected and operating.)
Accessing the context menu
You can access the context menu by following the steps below.
1. New e Series or New c Series:
i.
Selecting a location, object or target on-screen and pressing
the
Ok
button.
2. Touchscreen multifunction displays:
i.
Selecting an object or target on-screen.
ii. Selecting and holding on a location on-screen.
Using AIS
163
Summary of Contents for A65
