can obtain a Station License by filing FCC Form 605, which is
available from the FCC website listed above.
Operator License
FCC operator license requirement
An Operator License is not required to operate a Class B AIS
Transceiver within US territorial waters. However, a license is
required to operate the transceiver if you dock in a foreign port
(including Canada and Mexico) or leave a foreign port to dock in a
US. port. You can request a Restricted Radiotelephone Operator
Permit from the FCC by filing Form 753.
Industry Canada
Industry Canada license requirement
You do not need a license to operate this transceiver within
sovereign waters of Canada or the US. You will need a license to
operate this radio outside of Canada or the US. To obtain Industry
Canada licensing information, contact the nearest field or regional
office, or write:
Industry Canada Radio Regulatory Branch
Attention: DOSP
300 Slater Street
Ottawa, Ontario
Canada, KIA OC8
The following information about the radio is required to complete the
license application:
• Industry Canada Certification Number: 4069B-AIS500
• FCC Type Number: PJ5–AIS500
• FCC Type Accepted: Parts 15 and 80
• Output Power: 2 Watts
• Modulation: GMSK
• Frequency Range: 156.025 to 162.025 MHz
Maritime Mobile Service Identity (MMSI)
A nine-digit Maritime Mobile Service Identity (MMSI) number is
required to operate the AIS500 transceiver.
Note:
You can request an MMSI number from the FCC when
you apply for a Station License. If your vessel does not require
a license, you may obtain an MMSI by contacting BoatUS
(www.boatus.com). Once obtained, you can program the MMSI
number into your AIS500 as described in the documentation
accompanying the transceiver.
Programming the MMSI & static data
Important:
In the United States of America, it is a violation of the
rules of the Federal Communications Commission to input an
MMSI that has not been properly assigned to the end user or to
otherwise input any inaccurate data in this device. The MMSI
and Static Data must be entered only by a Raymarine dealer or
other appropriately qualified installer of marine communications
equipment on board vessels. Instructions for entering the MMSI
and static data are given in the documentation on the CDROM
supplied with the AIS500 transceiver.
Once static data has been programmed, you must not change
it. If the information programmed is no longer correct, contact
the Raymarine help desk or the dealer or retailer from whom you
purchased the transceiver, to arrange reprogramming.
10
Summary of Contents for AIS500
