Chapter 1: Important
information
Product installation and
operation
Ensure safe effective use of the product.
• This product must be installed and operated in
accordance with the instructions provided. Failure to
do so could result in personal injury, damage to your
vessel and/or poor product performance.
• Raymarine® recommends certified installation by a
Raymarine® approved installer. A certified installation
qualifies for enhanced product warranty benefits.
Contact your Raymarine® dealer for further details,
and refer to the separate warranty document packed
with your product.
Warning: Potential ignition
source
This product is NOT approved for use in
hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable
atmosphere (such as in an engine room or
near fuel tanks).
Service and maintenance
This product contains no user serviceable components.
Please refer all maintenance and repair to authorized
Raymarine® dealers. Unauthorized repair may affect
your warranty.
RF safety notice
RF radiation statement
AIS
transceivers
generate and radiate radio frequency
(RF) electromagnetic energy (EME).
Compliance Statement (Part
15.19)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
FCC Interference Statement
(Part 15.105 (b))
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one of the following measures:
1.
Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment
and receiver.
3.
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
4.
Consult the dealer or an experienced radio / TV
technician for help.
Warning: FCC Warning (Part
15.21)
Changes or modifications to this equipment
not expressly approved in writing by
Raymarine Incorporated could violate
compliance with FCC rules and void the
user’s authority to operate the equipment.
Industry Canada
This device complies with Industry Canada
License-exempt RSS standard(s).
Operation is subject to the following two conditions:
1.
This device may not cause interference; and
2. This device must accept any interference, including
interference that may cause undesired operation
of the device.
This Class B digital apparatus complies with Canadian
ICES-003.
Industry Canada (Français)
Cet appareil est conforme aux normes d'exemption de
licence RSS d'Industry Canada.
Son fonctionnement est soumis aux deux conditions
suivantes:
1.
cet appareil ne doit pas causer d'interférence, et
2. cet appareil doit accepter toute interférence,
notamment les interférences qui peuvent affecter
son fonctionnement.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
7
