RF exposure
This equipment complies with FCC / ISED RF exposure limits for general
population / uncontrolled exposure. The wireless LAN / Bluetooth antenna
is mounted behind the front facia of the display. This equipment should be
installed and operated with a minimum distance of 1 cm (0.39 in) between the
device and the body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter, except in accordance with
FCC multi-transmitter product procedures.
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1.
This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
FCC Interference Statement (Part 15.105 (b))
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
1.
Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
4.
Consult the dealer or an experienced radio / TV technician for help.
Innovation, Science and Economic Development Canada
(ISED)
This device complies with License-exempt RSS standard(s).
Operation is subject to the following two conditions:
1.
This device may not cause interference; and
2. This device must accept any interference, including interference that
may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
Innovation, Sciences et Développement économique
Canada (Français)
Cet appareil est conforme aux normes d'exemption de licence RSS.
Son fonctionnement est soumis aux deux conditions suivantes:
1.
cet appareil ne doit pas causer d'interférence, et
2. cet appareil doit accepter toute interférence, notamment les
interférences qui peuvent affecter son fonctionnement.
Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
Disclaimer
Raymarine does not warrant that this product is error-free or that it is
compatible with products manufactured by any person or entity other than
Raymarine.
Raymarine is not responsible for damages or injuries caused by your use or
inability to use the product, by the interaction of the product with products
manufactured by others, or by errors in information utilized by the product
supplied by third parties.
Electronic chart data
Raymarine does not warrant the accuracy of such information, and is
not responsible for damages or injuries caused by errors in chart data
or information utilized by the product and supplied by third parties. Use
of electronic charts provided by third parties is subject to the supplier's
End-User License Agreement (EULA).
10
Summary of Contents for AXIOM 2 XL
