7.7 Mounting
Axiom® 2 XL displays are mounted from the rear.
Important:
In above decks installations, marine-grade sealant should be used to seal
the gap between the edge of the mounting surface and the edge of the
display.
1. Ensure you have followed the relevant instructions for preparing the
mounting surface for either surface mounting or flush mounting.
2. Route the relevant cables to behind the mounting surface cut out.
This may be difficult or not possible once the display has been mounted.
3. With one person holding the display in place, the second person should
attach the mounting bars to the back of the display using the supplied
countersunk screws, in the 4 locations shown.
4. Secure the display using the provided mounting fixings (M5 bolt, wavy
washer, nut and foot, in the 4 locations shown).
Depending on the thickness of the mounting surface, the washer and
nut may be located:
• between the mounting bracket and mounting feet, as shown in (1) and
(2) below, or:
• after the mounting bracket, as shown in (3) and (4) below.
5. Using a 4 mm Hex (Allen) wrench, tighten the mounting bar bolts, ensuring
that the feet are tight against the rear of the mounting surface.
6. Using a 8 mm wrench or adjustable wrench, tighten the nut against the
washer and the mounting bar to lock in position.
The nut should be tightened sufficiently to securely hold the display in
position.
33
Summary of Contents for AXIOM 2 XL
