14.1 External alarm connection
An external alarm can be connected to the
ALARM | VIDEO 2
connector
located on the rear of the display, using the Video In/Alarm out cable
accessory (part number: A80235). The alarm buzzer sounds an audible alert
tone when an alarm is triggered on the display.
Note:
• To ensure a secure connection to the display, twist the locking collar on
the
ALARM | VIDEO 2
connector so that it is in the locked position.
• The alarm to cable connection should be made using suitable connectors
(e.g. crimps), and then covered in insulation tape or similar to ensure the
connection is secure and watertight.
1.
External alarm buzzer (part number: E26033) — Not supplied.
2. Connection — Wires must be connected
Black
to
Black
and
Red
to
Purple
.
3.
Video in/Alarm out cable (part number: A80235) — Not supplied.
4.
Display’s
ALARM | VIDEO 2
connector.
14.2 GNSS (GPS) antenna connection
A passive antenna, such as the GA200 (part number A80589) is required to
obtain a position fix using the display’s built-in GNSS (GPS) receiver. The
antenna is connected to the
GPS ANTENNA
connector located on the rear of
the display.
1.
Passive GNSS (GPS) antenna:
•
GA200
(part number: A80589), or
•
GA150
(part number: A80288)
2. Display’s
GPS Antenna
connector.
For installation details, refer to the documentation provided with your GNSS
(GPS) antenna.
Alarm buzzer and GNSS antenna connections
59
Summary of Contents for AXIOM 2 XL
