6. Remove the mounting template.
7. The pedestal has a transit cover fitted over the open array. This cover must be left in place until
the open array antenna is fitted to the pedestal.
8. Insert the studs no more than 11 mm into the holes in the pedestal base, and hand-tighten. If
the supplied studs are not long enough for the mounting surface thickness, use M10 stainless
steel, grade A4-70 studding of a suitable length.
Important:
Ensure the vents on the underside are not blocked.
9. Pass a a suitable steel cable or chain through the 20 mm eyebolt holes. Once secure, lift the
pedestal and test it fits correctly in its final mounting position.
Important:
Ensure the pedestal is orientated correctly.
46
Summary of Contents for CYCLONE
