Installation
15
Securing the scanner to the mounting platform
Note:
The M8 bolts that secure the Digital Radome scanner to the
mounting platform require a torque of 20Nm (177lbf.in). Use the
supplied "Denso Paste" to lightly coat the mounting bolts.
To prevent damage to the base of the Digital Radome scanner, you must
not insert more than 25mm (1 inch) of each bolt in to the base of the
scanner, as shown in the following diagram:
Setting up the scanner
Before you go to sea
It is important to check the installation before you go to sea. This involves
aligning the scanner and checking the system timing, using your multi-
function display.
These checks are described in the following sections.
EMC conformance check
Always check the installation before going to sea to make sure that it is not
affected by radio transmissions, engine starting, etc.
FOR
W
ARD
D1
1363-1
Mounting platform
25 mm (1.0 inch)
maximum
D11368-1
