6.6 Measuring distances and bearings
You can use the databar information and the ruler to measure
distances in the chart application.
You can determine the distance and bearing:
• from your boat to the position of the cursor;
• between two points on the chart.
Note:
You must have Cursor Position data displayed in the
databar when making measurements. Go to
MENU > Databar
Setup > Configure
to customize the databar.
Positioning the chart ruler
In the chart application:
1. Position the cursor at the start point of your measurement or
bearing.
2. Select the
NAVIGATION
softkey.
3. Select the
RULER
softkey.
4. Position the cursor at the end point of your measurement or
bearing. The range and bearing is displayed.
5. Press the
OK
button to fix the new ruler position.
Repositioning the chart ruler
In the chart application, with the ruler displayed:
1. Select the
NAVIGATION
softkey.
2. Select the
RULER
softkey.
3. Use the
ADJUST A
or
ADJUST B
softkey to select the start
or end point, as appropriate.
4. Move the cursor to the new ruler position.
5. Press the
OK
button to fix the new ruler position.
Clearing the chart ruler
In the chart application:
1. Select the
NAVIGATION
softkey.
2. Select the
RULER
softkey.
3. Select the
CLEAR RULER
softkey.
Using the chart
79
Summary of Contents for E90W
