Description
Option
[VRM/EBL reference:]
Determines the reference point
used for VRM/EBLs.
•
True/Mag
When set to
[True/Mag]
bearing is measured from the
display’s selected bearing
reference (i.e.: True or Magnetic
north). The display’s bearing
reference can be specified from
the
[Units]
menu:
[Homescreen >
Units > Bearing]
.
•
Relative
When set to
[Relative]
bearings are taken from the Ships
Heading Marker (SHM).
[Interference rejection:]
Suppresses interference from other
close by radar scanners.
•
On
•
Off
[IR level:]
Determines the level of suppression
used. The higher the suppression
the less interference will be
displayed.
Note:
Only available when
[Interference
rejection]
is enabled.
•
Level 1
(lowest suppression)
•
Level 2
•
Level 3
•
Level 4
•
Level 5
(highest suppression)
[Main Bang Suppression (MBS):]
MBS eliminates saturation which
appears immediately around your
vessel.
•
On
•
Off
[Target expansion:]
When enabled, increases the radar
pulse length to provide larger target
returns.
•
On
•
Off
[Bearing alignment:]
Enables you to align the radar image
correctly in relation to your vessel’s
bow.
• 179.5° Port to 180° Starboard
Description
Option
[Sea clutter curve (manual mode):]
When the sea sensitivity control is
set to manual the sea clutter curve
setting is available.
Radar echoes produced by waves
can make it difficult to distinguish
between waves and real objects.
these echoes are known as ‘sea
clutter’.
The sea clutter curve setting adjusts
your radar scanner’s sensitivity to
sea clutter. The higher setting will
display less sea clutter.
•
1
•
2
[Transmit frequency]
Changing the transmit frequency
can reduce interference on the radar
image by shifting the frequency
band used by your radar scanner.
Note:
The transmit frequency settings is
only not available when the radar
range is set to less than 1/2 nm.
•
Low
•
Normal
•
High
[Reset advanced settings]
Resets the advanced settings to
factory defaults.
N/A
Databoxes tab
Settings
Description
[1:]
Determines the data item displayed
in databox 1.
[2:]
Determines the data item displayed
in databox 2.
[3:]
Determines the data item displayed
in databox 3.
131