2.1 Handbook information
This handbook contains important information regarding the p70
and p70r Pilot controller.
About this handbook
This handbook describes how to operate your product in conjunction
with compatible peripheral equipment.
It assumes that all peripheral equipment connected to the system
is compatible, correctly installed and commissioned in accordance
with the products installation instruction. This handbook is intended
for users of varying marine abilities, but assumes a general level of
product knowledge, nautical terminology and practices.
p70 / p70r Handbooks
The p70 / p70r Pilot controller has the following handbooks available:
Description
Part number
Installation and commissioning
instructions
87132
Operating instructions (quick
reference)
86142
User reference handbook
81331
Mounting template
87130
Additional handbooks
Description
Part number
SeaTalk
ng
reference manual
81300
SPX system installation guide
87072
SeaTalk to SeaTalk
ng
converter
87121
The latest version of documents are available to download as PDF’s
from
www.raymarine.com
.
Please check the website to ensure you have the latest version.
Before using your pilot controller
Before using the pilot controller under way it is important that it is
properly commissioned and set up as described in the installation
instruction.
First time set up
The first ever time the pilot controller is powered on, you will be
shown on-screen instructions for the initial set up. If your pilot
controller has been installed by a professional installer, first time set
up and commissioning may already have been carried out, if unsure
check with the dealer.
The first time set up screens takes you through the following:
• Language selection
• Vessel type selection
If a pilot controller already exists on your system then this procedure
may be skipped and the p70 / p70r will adopt the same settings as
the already installed pilot controller.
Note:
If calibration has not been undertaken then the display will
alarm ’Calibration required’ and then show ’Starting’ on the display
Commissioning
Before using your autopilot system for the first time you must ensure
that the system has been correctly commissioned in accordance
with the supplied installation instruction. Commissioning procedures
which must be carried out are:
• Dockside calibration (Dealer settings on SeaTalk)
• Seatrial calibration
12
p70 / p70r Pilot controller User reference
Summary of Contents for P70
