p70r Mounting
D12105-1
1. Check the selected location for the unit. A clear, flat area with
suitable clearance behind the panel, is required.
2. Fix the appropriate cutting template supplied with the product, to
the selected location, using masking or self-adhesive tape.
3. Using a suitable hole saw, make a pilot holes in each corner of
the cut-out area.
4. Using a suitable saw, cut along the inside edge of the cut-out line.
5. Ensure that the unit fits into the removed area and then file
around the cut edge until smooth.
6. Drill four holes as indicated on the template to accept the
securing screws.
7. Peel the backing off of the gasket, and place the adhesive side of
the gasket onto the display unit and press firmly onto the flange.
8. Connect cables to the unit.
9. Slide the unit into place and secure using screws provided.
Note:
Drill, tap size, and tightening torque is dependent on the
thickness and type of material the unit is to be mounted on.
Location and mounting
33
Summary of Contents for P70
