RSS standard(s).
License-exempt.
This device complies with ISEDC
Economic Development Canada
Innovation, Science and
Chapter 1: Important
information
Certified Installation
Raymarine recommends certified installation by a
Raymarine approved installer. A certified installation
qualifies for enhanced product warranty benefits.
Contact your Raymarine dealer for further details, and
refer to the separate warranty document packed with
your product.
Warning: Product installation
and operation
• This product must be installed and
operated in accordance with the
instructions provided. Failure to do so
could result in personal injury, damage
to your vessel and/or poor product
performance.
• Raymarine recommends certified
installation by a Raymarine approved
installer. A certified installation qualifies
for enhanced product warranty benefits.
Contact your Raymarine dealer for further
details, and refer to the separate warranty
document packed with your product.
Warning: Potential ignition
source
This product is NOT approved for use in
hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable
atmosphere (such as in an engine room or
near fuel tanks).
Warning: 12 Volt dc only
This product must only be connected to a
12 volt dc power source.
Warning: Chassis grounding
Do NOT ground this product using the
chassis ground terminal.
Grounding this product to a vessel’s RF
ground may cause galvanic corrosion.
Warning: Positive ground
systems
Do not connect this unit to a system which
has positive grounding.
Warning: Switch off power
supply
Ensure the vessel’s power supply is
switched OFF before starting to install this
product. Do NOT connect or disconnect
equipment with the power switched on,
unless instructed in this document.
FCC
Warning: FCC Warning (Part
15.21)
Changes or modifications to this equipment
not expressly approved in writing by
Raymarine Incorporated could violate
compliance with FCC rules and void the
user’s authority to operate the equipment.
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
FCC Interference Statement (Part
15.105 (b))
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one of the following measures:
1.
Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment
and receiver.
3.
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
4.
Consult the dealer or an experienced radio / TV
technician for help.
Operation is subject to the following two conditions:
9
81377-1-en_US_PRINT.pdf 9
12/21/2017 9:05:36 PM
