Chapter 1: Important information
Warning: Product installation and operation
• This product must be installed and operated in accordance with the instructions
provided. Failure to do so could result in personal injury, damage to your vessel
and/or poor product performance.
• Raymarine recommends certified installation by a Raymarine approved installer.
A certified installation qualifies for enhanced product warranty benefits. Contact
your Raymarine dealer for further details, and refer to the separate warranty
document packed with your product.
Warning: Potential ignition source
This product is NOT approved for use in hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable atmosphere (such as in an engine room
or near fuel tanks).
Warning: Product grounding
Before applying power to this product, ensure it has been correctly grounded, in
accordance with the instructions provided.
Warning: Positive ground systems
Do not connect this unit to a system which has positive grounding.
Warning: Switch off power supply
Ensure the vessel’s power supply is switched OFF before starting to install this
product. Do NOT connect or disconnect equipment with the power switched
on, unless instructed in this document.
Caution: Power supply protection
When installing this product ensure the power source is adequately protected by
means of a suitably-rated fuse or thermal circuit breaker.
Water ingress
Water ingress disclaimer
Although the waterproof rating capacity of this product meets the IPX6 standard, water intrusion and
subsequent equipment failure may occur if the product is subjected to commercial high-pressure
washing. Raymarine will not warrant products subjected to high-pressure washing.
Disclaimer
Raymarine does not warrant that this product is error-free or that it is compatible with products
manufactured by any person or entity other than Raymarine.
Raymarine is not responsible for damages or injuries caused by your use or inability to use the
product, by the interaction of the product with products manufactured by others, or by errors in
information utilized by the product supplied by third parties.
EMC installation guidelines
Raymarine equipment and accessories conform to the appropriate Electromagnetic Compatibility
(EMC) regulations, to minimize electromagnetic interference between equipment and minimize the
effect such interference could have on the performance of your system
Correct installation is required to ensure that EMC performance is not compromised.
7
Summary of Contents for RCR-1
