Chapter 3: Adjusting SmartPilot Settings
37
difficult than the other groups. After pressing
auto
, the display will show
CAL ?
. When you see this, press the
1
and
+1
keys together to enter Dealer
Calibration.
4. When you have entered one of the Calibration groupings, press
disp
key to
scroll down through the items within that grouping:
Note: You can go backwards through the list by pressing and holding the disp key for one
second.
5. When you reach an item you wish to adjust, use the
1, +1, 10
and
+10
keys
(as appropriate) to change the value.
6. If you then want to adjust settings in another Calibration group, press
standby
and then repeat steps 2 to 5 as necessary.
7. When you have made all the changes you want to make, press and hold
standby
for two seconds to exit Calibration mode and save changes.
3.2 Display Calibration
Display Calibration allows you to select the type of bar graph and heading shown
on the SmartPilot display, and set the information to be shown on the data pages.
D9332-1
or
or
To adjust values
2 seconds
(save changes)
Data pages
Press
disp
for next page
Accessing Display
Calibration
Display Calibration
81282_1.book Page 37 Monday, October 2, 2006 1:58 PM
