28
S1000 Autopilot Installation Guide
7. Post installation
When you have completed the installation of your S1000 Autopilot, use the following
procedures to:
• Check the steering operation.
• Check the system for leaks.
• Switch on the autopilot, then use the commissioning procedure, to correctly set up the
autopilot.
Steering operation
Turn the wheel from hard over port, to hard over starboard. If the steering operates
satisfactorily, proceed with the other post installation checks.
If the steering feels uneven and/or less responsive than it was before you installed your S1000
Autopilot, you may need to bleed the entire steering system. To do this, use the purge
procedure at the following web address:
http://www.seastarsteering.com/OUTBOARD/oboard.htm?../FILL_PURGE/FillPurge.htm&1
Checking for leaks
Checking for leaks (sheet 1)
Ensure all hydraulic joints are secure, then turn
the wheel to port. When the hard over point is
reached, continue turning to port to pressurize the
port lines, until the safety valve releases. At this
point, the fluid in the port lines will be at
maximum pressure and the wheel has a 'lumpy'
feel when turned to port.
1.
D7502-1
With the port lines at maximum pressure, check
the port lines for leaks, paying particular
attention to the joints.
If a leak occurs, turn the wheel to starboard to
release the pressure, then repair the leak and
repeat step 1.
2.
87040_1.book Page 28 Wednesday, December 22, 2004 12:32 PM
