30
S1000 Autopilot Installation Guide
Commissioning using Autolearn - sheet 1
WARNING:
At least 0.25 nm
(500 m) of clear sea space
At least 0.04 nm (100 m)
of clear sea spac
e
1 minute
(approximately)
Wind
To regain control of the boat at any time during Autolearn,
press STANDBY.
Continue on sheet 2
The Autolearn process takes your boat through a series of
zig-zag maneuvers, so a significant amount of CLEAR SPACE
is required in front of your boat. Do NOT start Autolearn
unless this space is available.
1.
Before you use the autopilot, run the inbuilt Autolearn facility to set up the
autopilot for your boat:
At the S100 remote, hold down
STANDBY
for 2 seconds,
to enter Pilot Setup mode
2.
Press
MODE
the necessary number of times to display
AUTOLEARN.
3.
Press
PILOT
to initiate Autolearn.
Pilot Setup
AUTOLEARN
CLEAR TO
MANEUVER?
D7508-1
4.
Ensure you have sufficient sea room to carry out the Autolearn, then steer
straight ahead and set the speed between 8 and 15 knots. Ensure the boat
is OFF the plane.
87040_1.book Page 30 Wednesday, December 22, 2004 12:32 PM
