19 Raymarine Sirius Weather System Installation Guide
Upgrading weather receiver software
The following section gives details of how to carry out an upgrade of your
SR50/SR100 weather receiver software.
Note:
Upgrades made to the SR50 can take approximately 20 Mins.
Before upgrading your weather receiver software, 2 pieces of hardware are
necessary to complete this process:
• A blank CompactFlash (CF) memory cartridge of 8 Megabytes capacity
or larger. Raymarine recommends using SanDisk brand CF cards.
• A CF reader/writer device for your PC or Mac. This device will be used
to copy the files downloaded from Raymarine.com to the CF card.
The CF reader/writer can be an external device (e.g. connected by USB
to your computer), or can be internal/built in.
Downloading the software upgrade
1. Point your web browser to
http://www.raymarine.com
2. Navigate to Customer support then Software update pages.
3. Download the latest version for your SR50/SR100 weather receiver.
4. Follow the onscreen instructions.
Uploading software to your weather receiver
Ensure your SR50/SR100 weather receiver and display are powered
OFF
:
1. Power up your display and SR50/SR100 unit. Wait until the Sirius
disclaimer is displayed then power down your
display only
. The
SR50/SR100 should remain powered with the Status LED flashing
amber.
2. Insert a CF card containing the software upgrade into the display.
Power up your display, you will see the Upgrade Utility screen. Ensure
the software upgrade version is highlighted in the left hand column, if
not use the trackpad to do so.
3. Press the Upgrade Remote Unit soft key.
4. Press the Upgrade Remote Unit on “Ethernet” soft key (SR100) or
“ST2” (SR50).The Upgrade progress bar appears.
The progress bar will begin updating. If they do not begin updating
within 30 seconds, check:
i. that the correct software revision was selected.
ii. that the SR50/SR100 weather receiver is powered
ON
and status
LED is flashing as per item 2 above.
iii. that the Display/weather receiver data cable connection is intact.
5. When the update process is complete, remove the CF card from the
card reader slot.
6. Press the REBOOT soft key. Your display will restart automatically.
Read Critical Warning
! Your SR50/SR100 weather receiver system
and display are now ready for normal operation. For full details of how
to operate your SR50/SR100 Weather Application refer to the relevant
display manual. A copy of this manual is available from the relevant
product pages at
www.raymarine.com
CRITICAL!
The SR50/SR100 weather receiver unit MUST remain
powered on for ten minutes after the upgrade is complete.
Failure to do so could result in incomplete processing of
the upgrade and subsequently the SR50/SR100 will not
properly reboot. The unit would then have to be returned
to Raymarine for reprogramming.
Summary of Contents for SR100
Page 47: ...44...
Page 48: ...45 Raymarine Sirius Weather System Installation Guide...
