64
ST1000 Plus & ST2000 Plus Tiller Pilots
Calibration Level 11: boat’s current latitude
When you have switched on heading error correction (Level 10), you need to use
Calibration Level 11 to input the boat’s current latitude (to the nearest degree).
Set the latitude using the
-1
,
+1
,
-10
and
+10
keys.
Note:
If the correction is switched off in Calibration Level 10 (i.e. set to ‘
0
’),Level 11 will
be omitted. When you press the
auto
key in Calibration Level 10 you will advance to Level
13.
Calibration Level 13: rudder damping
Adjust the value in Calibration Level 13 if the tiller drive ‘hunts’ when trying to
position the rudder.
• you can select 9 stages of rudder damping – initially, this option should be set
to 3
• if the autopilot is over-active in calm conditions, increase the damping
• if the course keeping is not tight enough, decrease the damping
• adjust the damping one stage at a time
Controlling access to calibration
You can prevent unauthorized access to calibration as follows:
1. Press and hold
-1
and
standby
together for 10 seconds until the display
shows CAL OFF:
2. Toggle the calibration access between On and OFF using the
-1
and
+1
keys.
3. Store the setting by pressing
-1
and
standby
for 10 seconds until the tiller
drive returns to normal operation.
D214-1
81130_5.book Page 64 Wednesday, June 15, 2005 3:48 PM
