Chapter 4: Calibration
23
4.3 Intermediate calibration
Intermediate calibration enables you to:
• Check the instrument software version.
• Check and if necessary set, the instrument status - either
MASTR
(master) or
REPTR
(repeater).
Follow the procedure in the
Intermediate calibration
flow diagram.
CAL
Note:
If there is no key activity when
the
Software version
screen
is displayed, calibration will
time out to normal operation
after 5 seconds,
Software
version
D4615-2
for approximately 4 seconds
hold down
and
Instrument
status
During normal operation
for approximately 2 seconds
hold down
and
To save your settings and return to normal operation from either screen,
INTERMEDIATE CALIBRATION
4.4 Dealer calibration
Dealer calibration enables you to set:
• User calibration on/off.
• Boat show mode on/off.
Dealer calibration also gives access to the
Factory defaults
screen.
This enables you to reapply the factory settings if you want to reset the
instrument to a known operating condition.
Follow the procedure in the
Dealer calibration
flow diagram.
157_2c04.p65
01/05/01, 12:23
23
Summary of Contents for ST40 Speed
