2
ST60+ Depth Instrument Owner’s Handbook
You can reset the
MIN
and
MAX
values by pressing the
reset
button for
3 seconds.
Operating with fishfinder products
Depth information is normally obtained from the Depth transducer, fitted as part
of the ST60+ Depth system. However, when the ST60+ Depth instrument is
connected to a SeaTalk system to which a compatible fishfinder is also connected,
the depth information is provided by the fishfinder all the time the fishfinder is
switched on.
Current depth
The current depth is shown in either
FEET
,
FATHOMS
or
METRES
. You can
select the units you want during User calibration.
The current depth screen also displays depth-trend indicator arrows to show
whether the depth is increasing or decreasing. A rising sea-bed is indicated by
and a lowering sea-bed by .
If there is no depth signal from the transducer for more than 30 seconds, the last
known depth is displayed and
LAST
flashes at the top of the screen. If depth
information is not received from the transducer or from SeaTalk, then dashes are
displayed.
Minimum & maximum depth
The minimum and maximum depth values are reset at power up. You can also
reset each one manually to the current depth, by holding in the reset button for
3 seconds.
Current
depth
Minimum
depth
Maximum
depth
Depth information
depth
3 s
8 second timeout
8 second timeout
reset
Resets to current
depth
Resets to current
depth
depth
depth
depth
D8161-1
81262_2.book Page 2 Friday, November 11, 2005 11:11 AM
