35
Chapter 5: Customising the System
Chapter 5: Customising the System
The ST600R provides setup and configuration options that are used
to adjust the settings for the ST600R itself, the compass, and the
autopilot.
Note:
You should perform the post installation procedures described in
Chapter 7 before adjusting any other calibration features.
There are three setup levels:
• User Setup, which controls compass setup, rudder calibration and the
ST600R display features
• Intermediate Setup, which controls the CodeLock security feature
and displays status and version number information (see Chapter 4)
• Dealer Setup, which controls the autopilot settings, and also the
calibration lock which can be used to prevent accidental access to
User and Intermediate Setup
The Dealer Setup options described in this chapter only apply if you
have installed the ST600R as the control unit for a Type 100/300
course computer. If you have installed the ST600R as a repeater unit
on an autopilot system, please refer to the Dealer Setup instructions
in the handbook for the main control unit.
5.1 User Setup
The flow chart on the following page shows the User Setup control
procedure, and the setup screens with their default settings.
Information on the functions of the different settings is given in the
remainder of this section.
The following points should be considered:
• Make sure that the autopilot is in Standby mode before you access
User Setup
• If the CAL LOCK screen is displayed instead of the initial page, you
need to turn off the lock feature in Dealer Setup
• Setup options are always saved on exit
Summary of Contents for ST600R
