36
Operation
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1.
Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately 6
seconds). All remote control and keyless entry codes are now erased. Reprogram any accessory you wish
to use.
ERASE ALL DEVICES INCLUDING myQ
®
ENABLED ACCESSORIES
1.
Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately 6
seconds).
2.
Immediately press and hold the LEARN button again until the learn LED goes out. All codes are now
erased. Reprogram any accessory you wish to use.
ERASE THE Wi-Fi® NETWORK FROM THE GARAGE DOOR OPENER
1.
Press and hold the black adjustment button on the garage door opener until 3 beeps are heard
(Approximately 6 seconds).
ERASE THE CAMERA SETTINGS
1.
Press and hold the reset button on the side of the camera for 10 seconds. The LED light will turn off,
then flash red.
You will need to set up your camera again after resetting it.
LEARN Button
Adjustment Button
Reset Button
To Open the Door Manually
To prevent possible SERIOUS INJURY or DEATH from a falling garage door:
•
If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED.
Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or
unexpectedly.
•
NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.
•
NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.
DISCONNECT THE TROLLEY
1.
The door should be fully closed if possible.
2.
Pull down on the emergency release handle.
RECONNECT THE TROLLEY
The lockout feature prevents the trolley from reconnecting automatically.
1.
Pull the emergency release handle down and back (toward the opener). The door can then be raised and
lowered manually as often as necessary.
2.
To disengage the lockout feature, pull the handle straight down. The trolley will reconnect on the next UP
or DOWN operation, either manually or by using the door control or remote control.
Summary of Contents for 87504RGD-267
Page 4: ...4 Tools Needed 3 16 5 32 5 16 7 16 1 2 5 8 9 16 1 4 7 16 Preparation...
Page 46: ...46 Notes...
Page 47: ...47 Notes...
