5793132-14
n
o
i
t
i
n
i
f
e
D
y
a
l
p
s
i
D
"Partially Open"
This message will display anytime the door is not on the fully open or close limit switch.
"Opening Door Running" This message will display when the door is running in the open direction.
"Closing Door Running" This message will display when the door is running in the closed direction.
"Sensor 2 activated"
"At Close Limit"
"TCS Paused"
"Aux 1 activated"
This message will display anytime the board is not receiving a signal from the Aux 1
when close button is pressed. Whether it is not connected, activated, or has
malfunctioned. If no sensor is required on Aux 1, select "None Connected" in the
program.
"Aux 2 activated"
"Locked Out"
The LCD display will read "locked Out" when either the on board chain hoist interlock, or
the door interlock, on terminal block 2 is activated. These connections will have a jumper
when not required.
When in Timer to close mode (TCS), and door is in the open position, if the stop button
is pressed while timer is still counting down it will pause the timer until either the open or
close button is pressed.
When in timer to close mode, and the door is in the open position, the display will read
the amount of time in seconds that is remaining until door closes. You can activate the
stop button to pause this countdown.
"Sensor 1 activated"
This message will display anytime the board is not receiving a signal from the sensor 1,
when close button is pressed. Whether it is not connected, activated, or has
malfunctioned.
"Aux Board Connected"
"Lock Bar Detected"
This message will display whenever the open button is pressed and the limit nut does
NOT come off the close limit switch with in a certain amount of time. If the door is stuck
down for any reason, the open cycle will shut down to save damage to the door.
"Close in XX sec."
This message will display anytime the board is receiving a signal from the close limit
switch and the open button is pushed.
This message will display when the operator is powered up, and the auxiliary contacts
board is connected to the main board via wiring harness.
"At Open Limit"
This message will display anytime the board is not receiving a signal from the Aux 2
when close button is pressed. Whether it is not connected, activated, or has
malfunctioned. If no sensor is required on Aux 2, select "None Connected" in the
program menu.
This message will display anytime the board is receiving a signal from the open limit
switch and the open button is pushed.
This message will display anytime the board is not receiving a signal from the sensor 2,
when close button is pressed. Whether it is not connected, activated, or has
malfunctioned. If no sensor is required on sensor 2, select "None Connected" in the
program.
LCD DISPLAY MESSAGES
