R.ESPINAR S.L.
AEi/01
16/22
PRINTER MODE
The microprocessor comes out from the factory with the configuration of manual printer.
To make possible printing a sterilization inform, if the printer has a switch called “PRINT”,
will only have to press it.
To print an inform manually from the microprocessor:
1.- Keep pressed switch “TEMPERATURE” (7), during some seconds, in the screen will
appear the message :”MANUAL PRINTING”.
2.- Press the switch (11) “PRO”, in the screen will appear: “PRINT NOW? NO”.
3.- Press the switch (9) “INCREASE”, in the screen will appear: “PRINT NOW? YES”
4.- Press the switch (11) “PRO” in the screen will appear: “PRINTING”, and it will give us
an inform of the last sterilization without data, as the following example:
DATA PRINTING RESULTS
In automatic printing mode, data concerning to temperature is suitable, step of the cycle,
and also the time of every step lasted and a final inform.
To set the automatic printing:
1.- Keep pressed the switch (7) “TEMPERATURE” during some seconds, in the screen will
appear the message: “MANUAL PRINTING”.
2.- Press switch nº (9) “INCREASE”, and in the screen will appear: “AUTOMATIC
PRINTING”.
3.- Press switch nº (11) “PRO”, and in the screen will appear “DATA CADENCE”, this
means that this will print data every 120 seconds. To modify the printing times press
switches “INCREASE/DECREASE”.
