DHG0000004 RB Universal SR10000™ Installation Manual
0
Figure - Open hatch routing method.
. Close the hatch gently and carefully
inspect the cable to make certain that it
is not bent, pinched or damaged. There
may be extra coaxial cable left once it has
been routed inside of the vehicle to the
desired location. You may coil and tie the
excess cable and place it near the IDU and
receiver. You may also cut the cable to
the length needed and install a new TNC
connector. Refer to Appendix A for proper
installation of TNC connectors.
. Once the cable has been routed from the
antenna to the IDU, the cable must be
properly secured to the roof rack crossbars
with tie-wraps. In appropriate situations,
you may use self-adhesive cable straps to
secure the cable to the vehicle (Figure -).
. Run the cable along the roof rack of the
vehicle, back to the hatch. With the hatch
open, route the cable behind the hatch to
inside the vehicle (Figure - ).
TOOLS & INSTALLATION
Only a trained automotive
installer should run cable
or remove the vehicle’s headliner.
Improperly removing this material may
result in tearing, water infiltration and
other damage to the vehicle and its
contents. RaySat is not responsible
for damage caused to vehicles due to
improper drilling or removal of interior
headliners.
TOOLS & INSTALLATION
Prior to the cable entering the
vehicle, create a drip loop to
prevent water from entering the vehicle
and causing damage
Figure - Tie wrap cable to roof rack.
7 Installing the Antenna Cable
