User Manual
8
time of day.
NO-RECORD
[ white]: DVR will not record during the time.
NORMAL-RECORD
[ red]: DVR will record continuously.
SENSOR-RECORD
[
S
]
: DVR will record when sensor or motion is triggered.
NOTE:
In order to activate the record schedule, press the
[ ]
record button when viewing the
cameras. After pressing the
[ ]
record button, if schedule is set to “NORMAL-RECORD” , the
DVR will start to record immediately; if the schedule is set to be “SENSOR-RECORD” , the
DVR will not start recording until a motion is detected by the DVR or an installed sensor is
triggered.
5.8
Sensor Setup
CONT:
Continuous alarm until any key is pressed.
OFF:
No alarm
Note
: Sensored Record Time and Alarm On Time are measured in seconds
5.9
H/W Sensor Setup
Note:
Sensors and extension alarm are not included with the DVR system and may be purchased
separately.
The time line indicates 24 hours of a day based
on AM/PM (0 = 12).
Press [
▲
,
▼
,
◄◄
or
►►
] button to select a
time point, press [
SEL
] to modify the recording
mode.
Sensored Record Time indicates how long the
recording time is when the motion or sensor is
triggered.
Alarm On Time indicates whether the buzzer
will sound when motion is detected.
Hardware Sensor Setup
:
There are 3 different modes for sensor setting: NOT
INSTALLED, NORMAL-CLOSE and
NORMAL-OPEN. Consult the alarm purchased for more
details on which setting is required.
RDCORD SCHEDULE
AM PM
0… 3… 6… 9… 0… 3…. 6… 9…
NO-RECORD
NORMAL-RECORD
SENSOR-RECORD
( )MOVE (SEL)SELECT (MENU)EXIT
S
SENSOR SETUP
SENSORED RECORD TIME 30
ALARM ON TIME OFF
H/W SENSOR SETUP
MOTION DETECTOR SETUP
( )MOVE (SEL)SELECT (MENU)EXIT
H/W SENSOR SETUP
CHANNEL-1 TYPE:NORMAL-OPEN
CHANNEL-2 NOT INSTALLED
CHANNEL-3 NOT INSTALLED
CHANNEL-4 NOT INSTALLED
( )MOVE (SEL)SELECT (MENU)EXIT
Summary of Contents for D6004
Page 1: ...User Manual 0...
