Raytech USA, Inc. All rights reserved
Ver. 1.13
2
SAFETY PRECAUTIONS!
1
–
0
The following safety precautions must be observed during all phases of operation, service, and repair of this
instrument. By purchasing this equipment the purchaser assumes all liability for the operation and use of this
equipment. The intended use of the instrument, its design and manufacture, is to be conducted within the
precautions or other specific warnings located within this manual. Failure to comply with these precautions and
other specific warnings violates safety standards of design, manufacture, and intended use. Raytech USA, Inc.
assumes no liability for the operation and use of this equipment.
SAFE OPERATION
Only qualified knowledgeable persons should be permitted or attempt to operate this test equipment. All test
personnel should fully familiarize themselves with the correct application and operation of this and all test
equipment prior to operation. Persons directly, and indirectly engaged in the operation of this test equipment should
keep clear of all high voltage apparatus while conducting tests and measurements.
BEFORE APPLYING POWER
Make sure the transformer to be tested is cleared and removed from operation.
GROUND THE INSTRUMENT
To minimize shock hazard, the instrument must be connected to a properly grounded receptacle (with the supplied
power cord) or a good known earth ground point via the front panel ground connector (with the supplied safety
ground lead) when in use. Non-grounded instruments are dangerous and may cause instrument damage or personal
injury.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the instrument in the presence of flammable gases or fumes.
KEEP AWAY FROM LIVE CIRCUITS
Operating personnel must not remove instrument covers. Component replacement and internal adjustments must be
made by qualified service personnel. Do not replace components with power cable connected.
DO NOT SUBSTITUTE PARTS OR MODIFY INSTRUMENT
Because of the danger of introducing additional hazards, do not install substitute parts or perform any unauthorized
modification to the instrument. Return the instrument to a Raytech USA service department for service to ensure
proper operation and that safety features are maintained.
Instruments, which appear damaged or defective, should be made inoperative and secured against unintended
operation until they can be repaired by qualified service personnel.