RSSD AR
-
727H MANUAL 31
ADD/DELETE
ADD/DELETE
ADD/DELETE
ADD/DELETE
Enter Programming Mode
or
Use F1 or F2 to scroll to
and press
Use F1 or F2 to scroll to
and press
The Display will show:-
Enter the User Address, for this example
and press
(User Address is the memory slot into which the token will be
entered)
WARNING
*123456#
*MASTER CODE#
1. Add/Delete
1. Add Card ID
#
#
User Address :
F3: Prev F4: Next
(0-01023):00000
#
00000
Add Card ID
Before Proceeding with any token programming, please read the
following.
The last page of this manual is a token/memory slot record sheet. The blank
sheet should be photocopied and the photocopy kept up-to-date with the
location and number of each token added or deleted.
Failure to do so might result in valid tokens being overwritten when batches
of tokens are added en bloc, if deletion of individual tokens have left vacant
memory slots scattered amongst valid tokens.
If the first token in a new batch is directed to a single vacant memory slot,
then the rest of the batch will overwrite (and replace) any subsequent valid
tokens in the memory.
For this reason, it is advisable to read the section “Checking Available
Memory Locations” (page 38 opposite) before adding tokens since the F3
and F4 functions can be used to identify the location and quantity of vacant
memory slots even if the Token Record Sheet has not been kept up-to-date.
This applies to all firmware versions up to and including 7V4.
Version 7V5 automatically avoids overwriting valid tokens.
A record should still be kept of token location in the memory,
however, to facilitate deletion of specific tokens.
Continued Over
