PILOTSTAR D
4--4
3060.DOC012
Edition: March 13, 2009
4.5
Ship--specific Parameters (CONFIG. on)
As a matter of principle, the autopilot is delivered with preset parameter values (see An-
nex -- 4, column DEFAULT).
As a principle, the adustment of the ship--specific parameters is only required on
the occasion of first installation or in case of system extension.
By entering new values, the DEFAULT values will be overwritten.
After installation or in case of system extension, the ship--specific parameters must ade-
quately be adapted.
On leaving the CONFIGURATION mode (CONFIG. OFF), the new parameter values will
be stored (see sections 2.4.1 and 4.5.1).
All ship--specific and operationally--conditioned parameters are permanently filed in an
EEPROM and will be available again even after a voltage failure.
Cold Start
(COLD STRT, Kap. 4.6)
By the cold start, all parameter values that have been entered by the user will be can-
celled. The AUTOPILOT assumes its initial state (first putting into operation).
The ”Default” parameter values are now effective with regard to control engineering.
The ship--specific parameter values can now be entered again.
Summary of Contents for AP02-S01
