2-11
For information and restrictions to “Individual Speed” or “Individual SEC”, see chapter
1.4.2.2.
CAUTION
Big differences of the latitude value, which may occur while switching
over from automatic to manual input, are included into the speed
error correction (SEC) calculation for 2-3 hours
2.7.4
Change Variation
1.
Open the overview page, see chapter 2.3.1
2.
Select Variation with the Select buttons (Figure 2-3/1 and 2).
3.
Press the Set button (Figure 2-3/11) to confirm the selection.
4.
Use the Select buttons (Figure 2-3/1 and 2) to switch the value.
- The changed value is displayed italic.
5.
Press the Set button to confirm the value.
After confirmation the values are saved in an internal table so the magnet compass
heading is corrected according to interpolation of the set values.
The display switches back to overview page.
Changing the variation is only possible, if it is not distributed by the
Distribution Unit, which can receive it from a NMEA RMC Telegram
