3-3
WARNING
The shielding clamp should not be used to clamp the connected
cables mechanically.
The cables have to be clamped separately.
1.
Strip the cable over a length of approx. 80 - 170 mm.
- Be careful not to damage the screening.
2.
Trim the screening until approx. 15 mm is on the cable.
Figure 3-1
Strip off the Cable Connection
The cable length to strip off must be adapted to the length between
the clamp and the terminals.
3.
Insert the cable ends into the terminal strip and tighten the terminal screws.
4.
Clamp the cable shield by fastening the suitable shielding clamp in the slits of the
bent mounting plate. The shielding clamp is available in three sizes.
