Gyro Compass Standard 22 NX
2 Operation
10000000015
8
Edition:001
2.3
Setting Into Operation
2.3.1
Pre-Operation Procedures
Procedure
1. Switch on the log for speed input.
2. Switch on the GNSS receiver for position input.
2.3.2
Setting Into Operation
Procedure
Note
During the heating and settling stage a correct heading is not available.
A significant deviation of the gyro compass heading from true north may occur.
1. Switch on the gyro compass via the distribution board.
► The gyro compass is in the heating stage.
► The display shows the display page
Heading (Heating)
.
Fig. 1: Display Page: Heading (Heating)
Note
During the heating stage, no heading information is available.
Note
The heating of the gyro compass takes approximately 30 minutes. The heating time
depends on the temperature of the supporting liquid when the heating starts.
Summary of Contents for Standard 22 NX
