OPERATION
AUTOPILOT
NautoPilot 5000 Series
93
4002.DOC010102
Edition: September 2014
Table 15
Meanings of Parameter memory
Function
Figure 56/1
Actual values of the parameters yawing, rudder and counter
rudder. These values must not be identical to one of the below
parameter sets.
A selected parameter set (parameter set M1 is selected as
shown) can be changed with the ”Parameter” softkey at the ini-
tial display -- this changed parameter values are displayed as
”Actual”.
Figure 56/2
Parameter set M1, this parameter set is selected via the check
box.
If a parameter set is selected, “Parameter Set x” will be dis-
played in the upper right corner of the display.
Figure 56/3
to
Figure 56/6
Parameter sets M2 to M5 (not selected -- only one parameter
set can be selected).
Figure 56/7
Softkey for switching back to the previous display without a
modification/change of a parameter set.
Figure 56/8
Softkey for modifying the selected parameter set (not for acti-
vating this parameter set).
To change a parameter set, press the appropriate softkey for the parameter set you wish
to change.
A small icon appears prompting the operator to press the ”SET” button for a parameter
set change.
