OPERATION
AUTOPILOT
NautoPilot 5000 Series
95
4002.DOC010102
Edition: September 2014
Table 16
Meanings of parameters for Parameter set
Function
Figure 57/1
Softkey for changing/entering the counter rudder parameter
(see also section 1.3.3). Value range: 0 to 9
(in increments of 1).
Use the ”+” and ”--” softkeys to make a change.
Changes must be acknowledged with ”SET”.
Figure 57/2
Softkey for changing/entering the rudder parameter (see also
section 1.3.2). Value range: 1 to 9) (in increments of 1).
Use the ”+” and ”--” softkeys to make a change.
Changes must be acknowledged with ”SET”.
Figure 57/3
Softkey for changing/entering the yawing parameter (see also
section 1.3.1). Value range: 1 to 6 (in increments of 1).
Use the ”+” and ”--” softkeys to make a change.
Changes must be acknowledged with ”SET”.
Figure 57/4
Softkeys for changing the selected parameter.
Changes must be acknowledged with ”SET”.
Figure 57/5
Softkey for switching back to the previous display, without a
transfer of changed values.
2.4
Switching ON/OFF
After switching on the supply voltage (24V DC) at a main switch board the
NautoPilot Operator Unit is switched on -- there is no separate ON/OFF switch.
For switching OFF, the supply voltage at a main switch board must be switched OFF.
