OPERATION
AUTOPILOT
NautoPilot 5000 Series
109
4002.DOC010102
Edition: September 2014
4.3.6.1
Preselected heading change in ”Heading Control” mode
Table 23
Procedure for changing preselected heading in ”Heading Control”
”Heading Control” mode is active.
The mode is displayed at the top right corner of the display
(Heading Ctrl.).
125.8
Preselected Heading
Turning the rotary knob will change the preselected heading
value.
Please note: After approx. 15 seconds of inactivity from the
rotary knob, the primary set heading value will be displayed
again.
This value is displayed in italic and colors are inverted.
The ”SET” LED (near the button) will flash (request to press
the ”SET” button).
Set Heading
125.8
Pressing the ”SET” button will transmit the preselected value
to the controller as the new ”set heading”.
The value is now displayed in non--italics and normal colors.
The ”SET” LED (near the button) will be off.
or