OPERATION
NautoPilot 5000 Series
126
4002.DOC010102
Edition: September 2014
Check
Comment
Track Limit
Adjust Track Limit threshold according to traffic in sea
area; the more traffic, the smaller the threshold.
Adjusted Track Limit must be the same as adjusted at the
ECDIS.
Softkeys “Limit”
“Limit Page”
(see also section 2.3.5.2 and 2.3.6.4)
OFF Position Limit Adjust Limit threshold for deviation between first and sec-
ond position sensor, e.g. position sensor and dead reck-
oning.
Softkeys “Limit”
“Limit Page”
(see also section 2.3.5.5 and 2.3.6.4)
Alarm/Status
The alarm, warning and status bar (top bar of the display)
should not be red/yellowish orange in colour.
The cause of alerts should be resolved.
Alerts should be acknowledged.
4.5.4
Switching off ”Track Control” and “Waypoint Steering” mode
“Track Control” and “Waypoint Steering” can be stopped by activating “heading control”
at the autopilot or by activation of a manual steering control.
“Track Control” mode can be switched off at RAYTHEON Anschütz ECDIS -- the AutoPi-
lot is switched to “Heading Control” mode automatically.
-- For switching over to Heading Control, see section 4.3.3.
-- For switching over to Standby, Override or Manual, see instruction below
Table 31
Procedure to switch off ”Track Control” mode
Standalone application
HAND
AUTO
Switching the ”Main Steering Switch” into position HAND,
switches the Autopilot to ”Standby”.
The lower LED for standby will light up.
The mode change is displayed at the top right corner of the
display (Track Ctrl.
Standby).
or
