OPERATION
AUTOPILOT
NautoPilot 5000 Series
127
4002.DOC010102
Edition: September 2014
Tiller
Activating a ”Tiller” (no NautoSteer Tiller) with an override
function, switches the Autopilot to Override mode.
Observe section 1.4.8.
Note:
The Autopilot can be activated at the connected Override
Operator Panel and starts in “Heading Control” mode at
once.
The lower LED will light up.
The mode change is displayed at the top right corner of the
display (Track Ctrl.
Override).
AS application
HAND
AUTO
Switching the ”Main Steering Switch” into position HAND,
switches the Autopilot to ”Manual”.
No LED for activated control mode will light up.
The mode change is displayed at the top right corner of the
display (Track Ctrl.
Manual).
or
Tiller
Activating a NautoSteer steering device (Tiller AS or Hand-
wheel AS) with an Override Operator Unit AS, switches the
Autopilot to Override mode.
Observe section 1.4.8.
Note:
An activation of the Autopilot with the Override Operator Unit
AS (button Autopilot), switches the Autopilot into “Heading
Control”.
The lower LED for standby will light up.
The mode change is displayed at the top right corner of the
display (Track Ctrl.
Override).
or
Tiller
Activating a NautoSteer steering device (Tiller AS or Hand-
wheel AS) without an Override Operator Unit AS switches
the Autopilot control mode off.
Observe section 1.4.8.
The lower LED for standby will light up yellow.
The mode change is displayed at the top right corner of the
display (Heading Ctrl.
Standby).
