Power button
RADAR
Operator Manual
2
−
8
3748DOC020102
Edition: 14.JAN.2005
2.2.1
Switching ON
Positioned on front, lower left side.
Pressing the button switches on the power.
D
The
Radar Utility Selector
window appears in the display.
Select the RADAR softkey in the window and press the
Left
button on the trackball.
D
After about 40 seconds, the message STANDBY appears in the image
center.
D
The system configuration diagram is shown in the center of the display
area (see Figure: 2
−
7).
Select the desired transceiver combination XCVR ..... and the
master/slave assignment if possible (system specific).
The STANDBY message changes to WARM UP.
D
After a few minutes the warm up period is
complete and the WARM UP message changes back to STANDBY.
D
NSC Radar is in STANDBY mode.
The NSC beeps when
the NSC radar software detects an internal or external malfunction;
a simultaneous alarm message is displayed.
Acknowledging the alarm message switches off the acoustic signal. The
alarm message is hidden, but it can be called up again.
NSC status
:
The transceiver is not transmitting.
The antenna is not rotating.
No radar video in PPI, STANDBY.
Service and setup menu accessible.
The operating temperature is maintained by the magnetron.
Summary of Contents for NSC 18
Page 1: ...3464 100 037 NSC 18 Navigational Radar System User Manual 3748DOC020102 Edition 14 JAN 2005...
Page 3: ......
Page 4: ......
Page 5: ......