3/
5
raytrix
GmbH
· We sharpen your image!
Schauenburgerstraße 116
·
D-24118 Kiel · Germany
www.raytrix.de
Setup for external triggering
•
Use the triggering cable supplied by Raytrix and connect it to the Hirose connector of
the camera (marked „C“ in picture below)
•
The cable is wired to the connector as follows:
•
Connect a power supply with 10V…25V DC to pins 1 and 2
•
Connect the source of your trigger impulse to pin 5
•
The trigger source must have the same ground potential as pin 1, a connection
from the negative or ground pin of the trigger source to pin 1 of the camera might
be necessary
•
A trigger impulse voltage of 10V is sufficient to trigger the camera
