Rayzist 2034vx, Manual

1/20/2015 (3:46 PM) 
2034vx & 2034vxa v6.0.doc 

2.13

  Dedicated Air Compressor Set-up

! NOTICE 

DO NOT connect air to the cabinet until you are 
instructed to do so in the operation manual.  Follow 
all procedures found in compressor manufacturers 
literature.

2.13.1

  It is highly recommended that you install a 

water trap to the compressor.  Moisture getting into 
the abrasive can cause the pressure pot to clog and 
prevent the flow of abrasive. If you are using a 
water trap, install it to the output connection on the 
compressor. This connection is generally after the 
air pressure regulator.

2.13.2

  Connect air hose to water trap.

2.13.3

  The end of the air hose should have a quick 

disconnect coupling that will connect to the fitting 
(N) on the pressure pot. 

2.13.4

  Turn on the compressor and let it fully charge 

with air but DO NOT connect the air hose to the 
cabinet yet. 

2.13.5

  Air compressors generally have an output 

regulator and two air pressure gauges.  One gauge is 
to indicate the pressure in the tank and the other is 
the output pressure the customer sets.  Set the 
output pressure regulator to 90 psi.

 
2.14

Height Adjustment 

2.14.1

 The 2034vx Adjustable Sandcarving system 

has an electrically powered height adjustment 
switch.  Height measured at the arm holes can be 
adjusted from 39 to 53 inches. The adjustment 
switch is located on the left side of the cabinet 
behind the access door. The adjustment switch 
should be left in the middle (stop) position unless 
the cabinet is being raised or lowered.  Make sure to 
avoid any pinch point, and ensure there is proper 
clearance when raising and lowering the cabinet. 
Cabinet should automatically stop at the minimum 
and maximum heights. 
 
 

UP

DOWN