1/20/2015 (3:46 PM)
2034vx & 2034vxa v6.0.doc
3.0
OPERATING INSTRUCTIONS
! NOTICE
When a ball valve handle is parallel to the valve or
pluming, the valve is wide open. When a ball valve
handle is perpendicular to the valve, it is completely
closed.
3.1
Pressure Pot Settings:
The Pressure Pot
has two adjustment ball valves that can regulate the
abrasive/air flow mixture. The standard settings for
the pressure pot should be made as follows:
3.1.1
Set Abrasive Flow Valve (D) at approximate
half way open or approximately 45° angle.
Abrasive
45º
Air Flow
45º
Set Air Flow Valve (B) approximately half way
open or at 45° angle. Adjustments will need to be
made as wear occurs to Blast Hose (K) and Blast
Nozzle (T).
! NOTICE
Abrasive Flow Valve (D) usually does not require
adjustments from the 45 degree position unless
there are drastic pressure changes, or larger nozzle
orifices are used.
3.2
Connecting Air to Cabinet
3.2.1
Before connecting the air hose from the
compressor to the pot, make sure the Air Inlet Valve
(C) is in the “OFF” position (horizontal) and the air
compressor has been set up according to
instructions found in the Rayzist setup guide.
3.2.2
Connect the compressor air hose to the Air
Inlet Valve Quick Disconnect Plug (N) but DO
NOT turn the air inlet valve (C) to the on position
yet.
! NOTICE
The pressure pot is equipped with a safety relief
valve (U). If the pressure from the air regulator (A)
rises above 100 psi the relief valve (U) will pop
open and release air. Since your incoming air is to
be adjusted to 80-90 psi this should never happen.
This is a safety device and should never be used to
drain air from the pressure pot. Draining air from
the pot using this valve will cause abrasive to enter
and damage the regulator.
! NOTICE
The air pressure regulator (A) sets the blasting
pressure, which can be seen in gauge (H) only after
the pressure pot has been pressurized. It is factory
set at 30 psi.
Summary of Contents for 2034vx
Page 1: ... 2034vx 2034vxa Sandcarving System ...
Page 2: ......
Page 19: ......
Page 20: ...RAYZIST COM 800 729 9478 ORDER ONLINE WWW RAYZIST COM STORE ...