1/20/2015 (3:46 PM)
2034vx & 2034vxa v6.0.doc
! NOTICE
DO NOT add new abrasive to worn abrasive.
Always replace worn abrasive with new abrasive
using the following procedures. Always wear
respiratory protection for this procedure.
4.4.1.2
Remove the Blast Nozzle (T) from the Blast
Hose (K). Place the abrasive disposal bucket, with
lid attached, into the cabinet and close the door.
Turn on the dust collector. Place the nozzle of the
blast hose into the abrasive disposal bucket. Set
the Air Pressure Regulator Gauge (H) to 20 PSI by
adjusting Air Pressure Regulator Knob (A). Turn
off the Air Flow Valve (B). Press the Foot Pedal
(F) until the bucket is full or the pressure pot is
empty. Put worn abrasive in plastic bag and
dispose of according to local regulations. Repeat
as necessary until abrasive is completely emptied.
4.4.2
Adding New Abrasive
4.4.3
With the dust collector on, place unopened
50lb bag of abrasive into the cabinet. Slit the side
of the bag open allowing the abrasive to flow into
the bottom of the cabinet. Close the side door and
empty the remainder of the bag using the front
armhole access. After the dust has cleared remove
the bag from the cabinet.
4.5
Viewing Glass Replacement
! WARNING
Edges of glass can be sharp and cut through your
skin. Wear protective gloves when handling the
glass.
4.5.1.1
The window consists of two 12
"
x 24
"
panes
of glass, the outer double safety laminate
(replacement not required), and the inner 1/8
"
thick single strength glass. The inner single
strength glass will get frosted over time and will
impair visibility.
! NOTICE
12
"
x 24
"
x 1/8
"
thick single strength window glass
can be purchased from a local glass retailer.
4.5.1.2
To replace: loosen (but do not remove) the
five window bracket screws on the bottom of the
window and the four bracket screws on the top of
the window. Carefully slide both panes of glass
out to the right or left of the cabinet.
4.5.1.3
Replace the single strength glass pane and
slide both back into the window brackets. Tighten
five bottom bracket screws so that the bracket is
firmly against the face of the cabinet. Tighten 4
bracket screws on top until glass is slightly
compressing the foam seal under the glass. DO
NOT over tighten these 4 screws.
4.6
Replacing FSV Sleeve (R)
! WARNING
Disconnect air and depressurize pot before
replacing the Tube Sleeve.
4.6.1.1
The sleeve will fail when a small hole is
worn through the sleeve. Evidence of this is that
the foot switch will no longer turn off the flow of
abrasive and air.
4.6.1.2
To replace sleeve, Disconnect air and
DEPRESSURIZE the pressure pot according to
the instructions in operation manual.
Summary of Contents for 2034vx
Page 1: ... 2034vx 2034vxa Sandcarving System ...
Page 2: ......
Page 19: ......
Page 20: ...RAYZIST COM 800 729 9478 ORDER ONLINE WWW RAYZIST COM STORE ...