Rayzist 2034vx, Manual

1/20/2015 (3:46 PM) 
2034vx & 2034vxa v6.0.doc 

2.5

Removal from Pallet.

! WARNING 

Removal of the cabinet from the pallet requires 
at least two people.

2.5.1

The cabinet is bolted to the 4x4 blocks 

mounted on the pallet.  Locate the bolts and remove 
with 

¾

 inch opened end or socket wrench. 

2.5.1.1

With two people slide the cabinet off from 

one side so two of the casters will touch the 
ground at the same time. 

2.5.1.2

Once the first two casters are touching the 

ground carefully slide the remaining part of the 
pallet out from under the cabinet. 

2.6

Footswitch Valve and Blast Hose 

Setup

2.6.1

Locate the Foot Switch Valve (E) and blast 

hose (K) assembly in box at bottom of cabinet.  

2.6.2

On some shipments it is required to attach pipe 

union nut (J) to fitting at the bottom of the pressure 
pot.  Use wrench to tighten. 

2.7

Foot Petal Connection 

The foot petal (F) has a short hose and a long hose 
with quick disconnect fittings.  Connect the short 
hose to quick disconnect fitting on footswitch valve 
(E).  Connect the long hose to the quick disconnect 
fitting located between water separator (G) and the 
air inlet valve (C). 
 
 
 

2.8

Dust Bag Installation

2.8.1

Remove (by pulling) rubber plug from bottom 

hole. (The rubber plug must be used if no bag is 
installed). 

2.8.2

2034vx: 

2.8.2.1

Remove metal ring clamp. 

2.8.2.2

Install bag over disk with several inches of 

bag above the disk. 

2.8.2.3

Attach ring clamp over bag and disk and 

lock clamp. A good portion of the bag should be 
laying on the floor. 

2.8.3

2034vxa

: 

2.8.3.1

Install bag over disk with several inches of 

bag above the disk. 

2.8.3.2

Use a zip tie to secure the bag tightly around 

the disk. 

2.8.4

When cabinet power is turned on the bag 

should collapse, indicating that it is sealing the dust 
collector. If the bag does not collapse then the bag 
must be replaced.  

2034vx Model 

2034vxa Model